3/23/2023 0 Comments Ip camera not connecting to wifi![]() ![]() If this way doesn’t work, please scan the QR code to add the camera.ī、If you can’t go to the third step, please reduce the number of the Wi-Fi users, and delete the special characters of your Wi-Fi password.Ĭ、If you can’t go to the forth step, please try again, if it still doesn’t work, please contact the seller. (4)“Internet connected welcome to use cloud camera”Ī、If you can’t go to the second step, please check your Wi-Fi channel is not hidden, and the Wi-Fi router can’t be so far from the camera. Go to the WiFi settings and set up the SSID and password. Run the free ZOSI Client software on computer. Connect the wireless IP camera to the router via an Ethernet cable. ![]() Once it is selected you will be asked to input the Wi-Fi password for your network into the Input Password field. For more details, please visit How to Activate Wireless Settings of WiFi IP Cameras. ![]() Step 3: From the Wi-Fi list, click on the SSID associated with your network. My camera wont connect to WiFi The camera is disconnected from power The camera is unable to read the QR code Your camera is updating Your WiFi network is. (3)“Please wait for internet connecting” after getting the Internet ip address. If you were previously able to connect to your camera externally, but can no longer do so, your Internet Service Provider may have changed your external IP. In the Wi-Fi menu, click on the Enable checkbox to enable the Wi-Fi settings for your device. 1d) A Control Panel window should appear with the computer’s network connections. Make sure the correct password for the Wi-Fi network is being used. This clears short term memory and resets router tasks. (2)Select your Wi-Fi and login with your password, after the device makes a noise like “beep” you will hear this “Please wait for Wi-Fi connecting”. 1c) Look for the Change your network settings section. Power cycle the Connected Homes device for 30 seconds or perform a hard reset by pressing and holding the Reset button for 30 seconds. (1)“Please configure camera by scanning code or AP hot spot” There are four voice prompts in the progress After installation is complete, you will be asked to turn on GPS service when you use the app at the first time, if you choose not to turn on the GPS service, please uninstall and reinstall the app againĭ、Please confirm the camera wasn’t binding by the other account. Press the Reset button until hear the prompt toneī、Only support 2.4GHZ Wi-Fi, if your Wi-Fi router is 5GHZ, please switch to 2.4/5GHZ dual mode.Ĭ、Please turn on the GPS service before adding the device on the Android mobile phone. A、Please make sure the camera has been reset. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |